Mitel SX-200 - Manual (Page 34)

5312/5324 IP Phones User Guide
Park and Page
With Park and Page, you can park a call and initiate a page all in one step. Park and Page options
include
• Park and Page Set: After a call is parked, the system performs an all-set page.
• Park and Page Group: After a call is parked, the system pages your Paging Group.
• Park and Page: After a call is parked, you must enter the extension or Page Group number.
• Park and PA Page: After a call is parked, you must enter a Paging Zone number (0-9).
See "Programming a Feature Key" for information on assigning this feature to a Personal Key.
To park a call and page a call:
1. Answer or make a call.
2. Perform one of the following:
• To page all phones and the PA, press Park & Page Sets
Or
Press
(TRANS/CONF), dial *63 and dial *.
• To page all phones in a group and the PA, press Park & Page Grp
Or
Press
(TRANS/CONF), dial *63 and press #.
• To page an extension number, press Park & Page and dial the extension
Or
Press
(TRANS/CONF), dial *63 and dial the extension.
• To page all phones in a specified group and the PA, press Park & Page and dial the two-digit
Page Group Number
Or
Press
(TRANS/CONF), dial *63 and dial the two-digit Page Group Number, then #.
• To park a call in orbit and perform a PA Page to any or all nine Paging Zones, press Park &
PA Page and dial the Paging Zone number (0 for all zones, 1-9 for a specific zone).
Or
Press
(TRANS/CONF), dial *64 and dial the Paging Zone number (0 for all zones, 1-9
for a specific zone).
Note: To Park and Page a call using speed call keys, press (TRANS/CONF) to get dial tone.
Then press a speed call key that is programmed with the Park and Page access codes plus the digits
for the required paging option (For example, the digits for the required paging option could be an
extension number to page a single phone or * to page all phones plus PA paging).
28