Motorola DCP501 - Manual (Page 91)

O p e r a t i o n 8 1
DC P5 01 Us er Guide
Selecting Preset Radio Stations
To select preset radio stations with the DCP501:
1 Press
SOURCE
to tuner or press
AM / FM
. DCP501 display shows:
the last radio station tuned
the band (AM or FM)
the preset number assigned to that station (if any)
2 Press CHANNEL / PRESET ST on the front of the DCP501, or channel up/down on the remote
control to retrieve the desired preset number or directly enter the preset number using the
numeric buttons on your DCP501 remote control. Each preset station number is displayed
with its radio band and frequency.
S o u n d E f f e c t s
The DCP501 has many sound effects that can be selected and stored. When the SOURCE is CATV ,
cable TV providers may be using analog or Dolby Digital audio. The DCP501 allows you to select
and store a favorite sound effect for each. On any other
SOURCE , the DCP501 stores one analog
sound effect for each SOURCE and one Dolby Digital sound effect that is used on all non- CATV
SOURCES . Stored sound effects will be automatically selected by the DCP501 when returning to
that
SOURCE
. Some sound effects can only be used on analog (or PCM) audio, and some only on
Dolby Digital audio. The dts sound effect can only be used on dts audio. The following sound
effects can be used on analog (or PCM) audio.
Dolby Pro Logic II (movie, music)
Dolby Pro Logic
Dolby 3-Stereo
Stereo
Six DSP sound effects (Stadium, Concert, Theater, Arena, Club, Church)
The following sound effects can be used on Dolby Digital audio:
Dolby Digital
Dolby D+3Stereo
Dolby D+Stereo
Dolby D+PL II (movie, music, & emulation)
Dolby Pro Logic II (Dolby D+PL II) is a special case. Dolby D+PL II can only be used on
Dolby Digital audio if the signal is a Dolby Digital 2.0 signal. Sound effects selected on a
Dolby Digital 2.0 signal are stored separately from other selected Dolby Digital audio sound
effects, and will be automatically selected by the DCP501 when returning to that signal.
To operate the DCP501 audio mode:
1 Press audio
MODE
and the currently selected surround sound mode is displayed on the TV
and the DCP501 display.
2 Press audio MODE repeatedly to cycle through all available surround sound and DSP modes.