Important safeguards (continued), Regulatory information – Motorola DCP501 User Manual
Page 4
Important Safeguards (continued)
18
Object and liquid entry
Never push objects of any kind into this equipment through openings as they may touch dangerous voltage points or short-out
parts that could result in a fire or electrical shock. Never spill liquid of any kind on the product.
19
Servicing
Do not attempt to service this equipment yourself as opening or removing covers may expose you to dangerous voltage or other
hazards, refer all servicing to qualified service personnel.
20
Damage requiring service
Unplug this equipment from the wall outlet and refer servicing to qualified service personnel under the following conditions:
a
When the power supply cord or plug is damaged.
b
If the equipment has been exposed to rain or water.
c
If liquid has been spilled, or objects have fallen into the equipment.
d
If the equipment does not operate normally by following the operating instructions. Adjust only those controls that are
covered by the operating instructions as an improper adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the equipment to its normal operation.
e
If the equipment has been dropped or cabinet has been damaged.
f
When the equipment exhibits a distinct change in performance, indicating a need for service.
21
Replacement parts
When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer
or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other
hazards.
22
Safety check
Upon completion of any service or repairs to this video product, ask the service technician to perform safety checks to
determine that the product is in proper operational condition.
23
Heat
The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including
amplifiers) that produce heat.
24
Telephone equipment
Observe the following precautions when installing telephone modem equipment:
a
Never install telephone wiring during a lightning storm.
b
Never install telephone jacks in a wet location unless the jack is specifically designed for wet locations.
c
Never touch uninsulated telephone wires or terminals unless the telephone lines have been disconnected at the network
interface.
d
Use caution when installing or modifying telephone lines.
25
Battery usage
Notwithstanding any information provided by Motorola in this manual regarding the use of batteries, the end user assumes all
responsibility and liability to use and dispose of batteries in accordance with all applicable laws, rules and regulations. Motorola
will not be liable to anyone for the end user's failure to use and/or dispose of batteries in the proper manner and in accordance
with such laws, rules and regulations, or for any defect contained in batteries that may cause injury damage to persons or
property.
Regulatory Information
Federal Communications Commission Radio and Television Interface Statement for a Class ‘B’ Device
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in the residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
§ Re-orient or relocate the receiving antenna.
§ Increase the separation between the equipment and receiver.
§ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
§ Consult the dealer or an experienced radio/TV technician for help.
You may find the following booklet, prepared by the Federal Communication Commission, helpful: How to Identify and Resolve Radio-TV
Interference Problems, Stock No. 004-000-0342-4, U.S. Government Printing Office, Washington, DC 20402.
Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.