beautypg.com

Using the dcp501 tuner, Tuning radio stations, Presetting radio stations – Motorola DCP501 User Manual

Page 90

background image

8 0 O p e r a t i o n

DC P5 01 Us er Guide

U s i n g t h e D C P 5 0 1 T u n e r

This section describes:

How to tune radio stations

How to Program the DCP501 to tune to your favorite stations with the preset option

Tuning Radio Stations

To tune the radio on the DCP501:

1

Press

SOURCE

to tuner or press

AM

/

FM

. The DCP501 displays:

The last radio station tuned

The radio band— AM or FM (also shown on your TV)

The preset number assigned to that station if one has been assigned

2

Press AM/FM to select the radio band.

3

Press tune ST on the front of the DCP501 or ( ) on the remote control to change the
frequency. The frequency changes in 200kHz steps in FM and 10kHz steps in AM. Press and
hold tune on either the DCP501 front panel or the DCP501 remote control and DCP501
display

A U T O

icon turns on and the DCP501 scans to the next radio station.

If the tuned signal received is strong, the

T U N E D

icon turns on. For a stereo FM station,

the

S T

icon also turns on. If the signal is weak,

S T

(stereo) flashes. Press

FM MODE

to

improve the sound, which causes the receiver to operate in monaural (mono) mode, and the

S T

icon turns off. Press

FM MODE

again to return to stereo operation.

Note: The red

S T

(stereo) icon, which corresponds to AM/FM broadcasts, is different from

the

S T

(stereo) icon that corresponds to audio playback from all other sources.

Presetting Radio Stations

You can enter up to 30 preset stations to quickly access your favorite radio station. The 30
stations can be assigned to any combination of AM and FM stations that you would like. To
preset radio stations with the DCP501 tuner:

1

Tune to the desired radio station.

2

Press

SELECT

or

OK

. The

P R E S E T

icon flashes at the same time as the station number

below it, for example

1 0 5 . 3

.

3

Press

CHANNEL

/

PRESET

ST

to select the desired preset number to store the station on or

directly enter the preset number using the numeric buttons on your DCP501 remote control.

4

Press

SELECT

or

OK

to accept your changes. The

P R E S E T

icon and the preset number stop

flashing.

A new preset can be stored over an old one by following the same procedure.