Manitowoc Ice S - Manual (Page 46)

Maintenance Section 4
4-4 Part Number 000000966
F. Remove the water pump.
Water Pump Removal
• Grasp pump and pull straight down on pump
assembly until water pump disengages and electrical
connector is visible.
• Disconnect the electrical connector.
• Remove the water pump assembly from ice machine.
• Do not soak the water pump motor in cleaner or
sanitizer solution
G. Remove the evaporator tray from the bottom
of the evaporator.
• Loosen thumbscrew on left side of tray.
• Allow left side of tray to drop as you pull the tray to
the left side. Continue until the outlet tube
disengages from the right side.
Step 7 Mix a solution of cleaner and warm water.
Depending upon the amount of mineral buildup, a larger
quantity of solution may be required. Use the ratio in the
table below to mix enough solution to thoroughly clean
all parts.
Step 8 Use 1/2 of the cleaner/water mixture to clean all
components. The cleaner solution will foam when it
contacts lime scale and mineral deposits; once the
foaming stops use a soft-bristle nylon brush, sponge or
cloth (NOT a wire brush) to carefully clean the parts.
Soak parts for 5 minutes (15 - 20 minutes for heavily
scaled parts). Rinse all components with clean water.
Step 9 While components are soaking, use 1/2 of the
cleaner/water solution to clean all foodzone surfaces of
the ice machine and bin (or dispenser). Use a nylon
brush or cloth to thoroughly clean the following ice
machine areas:
• Side walls
• Base (area above water trough)
• Evaporator plastic parts - including top, bottom, and
sides
• Bin or dispenser
Rinse all areas thoroughly with clean water.
SV3091
WATER
PUMP
WATER
PUMP BASE
DO NOT SOAK
WATER PUMP
MOTOR IN
CLEANER OR
SANITIZER
SOLUTIONS
Solution Type Water Mixed With
Cleaner 1 gal. (4 l) 16 oz (500 ml) cleaner