Muratec QUADACCESS MFX-2590 - Manual (Page 58)

Closed Communication 2-9
1
2
Management
Closed Communication
When closed communication is set, fax messages are transmitted and received between
Muratec machines only (excluding some models). If a passcode is set, faxes can only
be transmitted and received with Muratec machines the same passcode set. Closed
communication can be set separately for transmission and reception. If you set passcode
polling, you can only perform polling with Muratec machines that also have the same
passcode set.
Setting Closed Transmission
If you set closed transmission, since the destination that faxes can be transmitted to is
limited, you can avoid transmitting faxes to a wrong destination due to an entry error.
Note
When using manual transmission (transmission using the [Monitor] function • , an
optional handset or external phone handset), the closed transmission function is
disabled, even if you set it to ON.
To set the passcode, refer to “ • Setting the Passcode ”. (See page 2-12.)
For details on the communication range using closed communication and passcodes, •
refer to “ Communication and Range of Passcodes ”. (See page 2-14.)
For details on setting closed transmission for a single communication, refer to •
Chapter 4, “Security Functions” in the Scanner and Fax Guide.
Press .
1
Press
2
the [Management] tab.
If an administrator password is set,
3
press [Admin Password].
If an administrator password is not set, proceed to step 5.
Enter the administrator password, and press [Enter].
4
Press [Security Communication].
5