Motorola DSR205 - Manual (Page 5)

IMPORTANT SAFETY INSTRUCTIONS
DSR205 User Guide iii
Lightning. To protect the product from damage caused by lightning and power line surges,
unplug it from the wall outlet and disconnect it from the antenna or cable system before a
lightning storm or if the unit will be left unattended or unused for a long period of time. Once a
storm passes, reconnect all antenna cables to the correct connectors. If you live in an area that
has many lightning storms, buy polarized surge protectors and surge protectors for the power
line, telephone line, and RF cable to protect your system from damage. Never attempt to
connect or disconnect any wires during a thunderstorm or lightning storm.
Note to the system installer:
The purpose of this reminder is to call your attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical. The illustration is an
example of antenna grounding according to the National Electrical Code Section 810, "Radio and
Television Equipment." Check your local building and electrical codes for other restrictions on antenna
grounding.
1. For the ground wire, use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminum, No. 17
AWG (1.0mm2) copper-clad steel or bronze wire, or larger.
2. Secure the antenna lead-in
wire and ground wires to the
house with stand-off
insulators spaced 4 ft.
(1.22mm) to 6 ft. (1.83mm)
apart.
3. Mount the antenna discharge
unit as close as possible to
the place where the lead-in
enters the house.
4. Use a jumper wire that is no
smaller than No. 6 AWG
(13.3mm2) copper, or the
equivalent, when using a
separate antenna grounding
electrode. See NEC Section
810-21(1).
5. In areas that are heavily prone to lightning storms install a lightning rod mounted to the top of the
antenna on the back side. Install a ground strap (2 AWG, or larger, of copper wire) from the lightning
rod to the rest of the antenna ground system.
6. Section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information about
the following items:
- Proper grounding of the mast and supporting structure.
- Grounding of the lead-in wire to the antenna discharge unit.
- Size of grounding conductors.
- Location of antenna-discharge unit.
- Connection to grounding electrodes.
- Requirement for the grounding electrode.