Motorola DSR205 - Manual (Page 14)

1
4
Acquiring a Signal
Complete the following steps to help you acquire a signal:
• Using the number keys on the remote control, tune to the authorization channel
(refer to the information supplied with your system). You should see a banner
with the channel number at the top of the screen.
• Press the OPTIONS key on the remote control. The Options menu will appear.
• From the Options menu, select option 6 (Change System Settings), and the
System Settings menu will appear.
• Select option 3 (Change Installation Settings), and on the Installation Settings
menu select option 1 (Tune in Satellite Signal).
• Look at the value in the box labelled Signal. If it is less than 10, make sure that
all connections between the satellite dish LNBF and the satellite receiver are
correct. If the signal strength remains below 10, contact your service provider
for assistance.
• Using the number keys on the remote control, enter the Provider ID supplied
by your service provider (refer to the information supplied with your system).
You can use the
3
key on the remote control to back up and make corrections.
• If the satellite dish is pointed at the correct satellite, the large field in the center
of the screen will turn green and display the message "Correct signal found". If
you do not see this message within 5 to 10 minutes, the satellite dish may be
pointed at the incorrect satellite. Contact your service provider for assistance.
Authorizing Your Receiver
• Press the EXIT key on
the remote control. Then
press the number keys
for the authorization
channel.
• Press the OPTIONS key
on the remote control.
The Options menu will
appear.
• From the Options menu,
select option 6 (Change
System Settings), and
the System Settings
menu will appear.