Motorola DSR205 - Manual (Page 25)

Using Your Remote
DSR205 User Guide 15
Using the remote control press the Menu button to bring up the Menu screen on
the receiver monitor (TV).
• Choose Options, choose Change System Settings.
• Choose Installation Settings.
• On the Installation Settings menu, choose Set Remote Control Address. Now
follow the instructions on the Remote Control Address screen.
• If you have multiple receivers, you will have to change the address on each of
them. Choose from following addresses: 0000, 0001, 0002, or 0003.
To program your remote control for each receiver, hold down the SAT key on the
remote control until the light flashes. Once the light begins to flash enter the
desired address.
Replacing the Remote Control Batteries
When the remote control batteries are worn out (discharged), the remote will stop
working. Replace the batteries as soon as possible to retain your programmed
codes. Once you remove the batteries from the compartment, you must replace
them within two hours to retain your programmable features. The remote control
for this unit may be powered by two AA batteries. Use only high quality, non-
corrosive batteries designed for use in electronic equipment.
Remember to replace
both batteries at the same time. To replace the batteries:
- Remove the cover by pressing down the back panel indentation and
removing the panel off the remote control.
- Position each battery in the battery compartment so that the flat base (-)
is against the spring and so that the raised contact (+) is against the
terminal. Make sure the batteries are securely seated. Replace the cover.
"Remote Energy Saver"
If you misplace your remote (i.e., it is stuck in your couch), and a key is
inadvertently pressed, the remote will automatically turn itself off after three
minutes.