Monessen Hearth ILDV20PV - Manual (Page 16)

16 83D0511
ILDV20/ILDV30 Fireplace Insert VeNt iNStALLAtiON
MANiFOLD ReMOVAL AND iNStALLAtiON
The manifold is shipped attached to insert. It may be removed to allow tight installation.
1. Remove glass door assembly following instructions on Page 29, Figure 34.
. Lightly tap on flange of exhaust baffle assembly towards you until disengaged. Remove baffle, manifold
and gasket from unit. Figure 10
3. ILDV0: Attach the solid closed baffle plate. ILDV30: Attach the slotted baffle plate. Figure 11
4. Feed exhaust flex through hole on top of insert and attach to manifold with hose clamp (not provided) or
other approved methods (check local codes). Insure the gasket is in place before securing the flex to the
manifold.
5. Re-attach exhaust baffle and manifold assembly in reverse order of Step .
6. Re-attach glass door in reverse order.
NOte: Insert has an adjustable baffle and may be adjusted as needed by loosening four (4) screws. Figure
11
FP1960
manifold assembly
9/08
Figure 10
Remove Manifold and Attach to Flex Vent
Gasket
Manifold
Baffle Assembly
FP1960 Front View
Side View
Flex Vent
Figure 11
Baffle Assembly and Adjustment
FP1961
baffle adjustment
9/08
Baffle Assembly
fp2156
ILDV baffle assembly
12/08
Baffle
Assembly
Baffle Plate
(For ILDV0)
FP156
closed Baffle Plate
Must use on iLDV20
iLDV20
Baffle Plate
Loosen Four (4)
Screws to Adjust
Bottom View
closed Position Bottom View
Open Position
FP1961
iLDV30
Baffle Plate
NOte: Make sure the correct
baffle plate is used.