MITSUBISHI ELECTRIC WD-62526 - Manual (Page 53)

Chapter 4. TV Menu Operations 53
Audio/Video Menu
Figure 13
Figure 13. Audio/Video Menu
A/V Memory Reset
A/V Memory Reset allows you to reset the A/V settings
for a specific input or device to the original factory set-
tings. Use ADJUST or to select the input or device in
the box and press ENTER. Note that the audio settings of
Balance, Listen to, and Language are general TV settings
unaffected by A/V Memory Reset.
To reset all A/V settings at once, including the three
general settings, perform an A/V Reset by pressing the
front-panel buttons GUIDE and FORMAT simultaneously.
Settings
Each input or device has its own A/V memory. Select the
input or device in the A/V Memory Reset box, then select
Audio or Video to adjust individual settings. Press ENTER
to close the menu and display the individual settings.
Use ADJUST or to select the individual settings
to adjust. Use ADJUST or to make changes. For
descriptions of the individual A/V settings, see the section
entitled “Audio/Video Menu” in chapter 4.
Video Mute
Video Mute lets you display a blue background when no
signal is being received on INPUT 1–3, COMPONENT 1
and 2, or HDMI 1 and 2.
Film Mode (480i signals only)
Auto is the default setting. With Auto selected, the TV
automatically detects and applies film-decoding correc-
tion for images that originated on 24-frame-per-second
film cameras and were then converted to 30-frame-per-
second video for broadcast. Try the Off setting if the TV
adds too many jagged edges to the images.
Audio/Video Menu
Using the AUDIO or VIDEO Button on
the Remote Control
To adjust individual Audio or Video settings directly with
the remote control:
1. Press AUDIO or VIDEO.
2. Press ADJUST or repeatedly to cycle through
the available options.
3. Press ADJUST or to change the setting. After
five seconds of inactivity, the setting display will dis-
appear.
When the original video was filmed on 30-frame-per-
second cameras, the Auto setting automatically applies
video decoding, the same as is used with the Off setting.
Film Mode is not effective for high-definition signals.
TV Speakers
This selection turns the TV’s internal speakers on or off.
You may select Off when sending the sound through a
separate stereo system or surround sound A/V receiver.
Note: To prevent damage from a sudden increase in
volume, make sure the TV volume is set to low before
setting speakers to On.