Mustang Survival MD0450 22 - Manual (Page 20)

17 MUSTANG SURVIVAL
CONVERSION CAP REMOVAL
Once the conversion cap is removed, the MD3196 becomes an automatic
inflation device. Firmly pull the conversion cap lanyard to remove the
conversion cap (Fig.25).
NOTE:Do not pull inflation lanyard when removing conversion cap
FIGURE 25
To remove the conversion cap when packed, pull the conversion cap
lanyard out from the opening of the cover of the LP’s right lobe. Visually
confirm the conversion cap has been removed from the valve opening.
Place the conversion cap in the anti-chafing cover, in the front pocket,
when not in use.
Repacking
IMPORTANT: Carefully read the entire Repacking instructions to
achieve a properly packed Inflatable Vest with LIFT
TM
If your Inflatable Vest with LIFT TM has been used and/or the hydrostatic
inflator replaced, always inflate through the oral tube and check that it
stays inflated at least overnight. With the dust cap in the top of the oral
tube, gently squeeze the Inflatable Vest with LIFT
TM until all air or gas
has been expelled (Fig. 11). Do not wring or twist the Inflatable Vest with
LIFT
TM . Put the oral tube dust cap back in its stowed position on the oral
tube (Fig. 26). Let the life jacket dry before packing.