Philips Magnavox CCX133AT - Manual (Page 26)

• If the channel you select has no
broadcast, the screen will be solid
blue. The screen will remain blue
until you select an active channel.
• Channel numbers (when tuned)
appear on-screen for a few seconds.
• The channel number will remain on-
screen at all times (except during
tape playback) if REMINDER is set
to ON. Details are on page 27.
• You cannot view closed captions of a
tape when the TV/VCR is in Counter
Only mode. The counter display will
replace the closed captioning display
on the TV/VCR screen. Details are on
pages 42 - 43.
Helpful Hints
1
Press the MENU button to display the pop up menu.
Function
Button
Pressed
Time
Channel
Counter
and
Counter
Memory Tape
Speed
12:00 AM STOP
CH10
SLP M 1:23:45
A status display, which includes the current time, channel, and
other information (see illustration of the status display at right),
will appear when you press the STATUS/EXIT button or certain
function buttons. You can bring up the status display at any time
by pressing the STATUS/EXIT button. Remove the status display
by pressing this button again. The contents of the status display
may vary.
ON MODE:
● Whenever a function button (REW(ind)/-, PLAY/▲, etc.) is
pressed, the status display will appear for five seconds.
COUNTER ONLY MODE:
● When a function button (REW(ind)/-, Play/▲, etc.) is pressed,
the status display will appear for five seconds. After five sec-
onds, only the counter will remain on-screen. To remove it,
choose ON or OFF in the ON-SCREEN MODE menu. (There
is an exception. When you press the STOP/▼ button, the sta-
tus display will appear for five seconds, then disappear.)
OFF MODE:
● The status display will not appear when you press a function
button. The channel number will appear briefly when you select
a channel if channels are programmed.
To choose an ON-SCREEN MODE, follow the steps below.
2
Press the PLAY/▲ button or the STOP/▼ button to select
VCR SETUP. Then, press the F.FWD/+ button.
3
Press the Number 3 button to select ON-SCREEN
MODE.
26 On-Screen Status Displays
4
Press the Number 1 button to select ON, the Number 2
button to select COUNTER ONLY, or the Number 3 but-
ton to select OFF. Your selection will appear on-screen.
5
Press the STATUS/EXIT button.