Setting up a usb driver in windows me – Motorola Communications Gateway User Manual
Page 35
30
Communications Gateway User Guide
X
Home
Exit
Introduction
Before You Begin
Installation & Configuration
FAQ
Troubleshooting
Glossary
License
Setting Up a USB Driver in Windows Me
Be sure the Motorola Communications Gateway CD-ROM is inserted into the CD-ROM
drive before you plug in the USB cable. A few seconds after you complete the USB
connection, the Add New Hardware Wizard window is displayed.
1
Click Next. Windows Me automatically searches for the correct USB drivers and
installs them. If installation is successful, the window at bottom left is displayed.
2
If the window at bottom left is displayed, click Finish. Otherwise, be sure the
Motorola Communications Gateway CD-ROM is correctly inserted in your CD-ROM
drive.
When you have successfully finished setting up the USB driver, you can continue with
“Configuring TCP/IP in Windows 95, 98, or Me”
Although your Motorola Communications Gateway model
number may be different than in the images in this guide, the
procedure is the same.