Motorola Communications Gateway - Manual (Page 19)

14 Communications Gateway User Guide
Cabling and Startup for a Single User, continued
Introduction Before You Begin Installation & Configuration FAQ Troubleshooting Glossary License
X
Home Print Exit
6 On the battery compartment cover, push in on the tabs, as shown by arrows 1 in the
illustration at top left.
7 Carefully remove the battery compartment cover by lifting up about 2 to 3 cm (1 inch)
and then pulling straight out. To avoid damaging the cover, be sure you rotate it only
slightly (arrow 2) before pulling it out (arrow 3).
For a description of the battery compartment, see “Battery Compartment” on page 6.
8 As shown at lower left, depress both battery snaps (arrows 1) while gently raising the
positive end of the battery (arrow 2).
9 When the battery rotates past the snaps, slide the battery out as shown below.
Be sure you do not damage the battery wires or terminals.
1
1
2
3
2
1
1
Battery snaps
Battery hook