Mercedes-Benz 2004 CLK 500 - Manual (Page 289)

289
Operation
Engine compartment
Checking engine oil level with the con-
trol system
When checking the oil level the vehicle
must
ț be parked on level ground
ț be at normal operating temperature
ț have been stationary for at least five
minutes with the engine turned off
To check the engine oil level via the
multifunction display, do the following:
̈ Turn the SmartKey in the starter switch
to position 2 or press the
KEYLESS GO* start/stop button twice.
The standard display ( ୴ page 129) should
appear in the multifunction display.
̈ Press button k or j on the
steering wheel until the following
message is seen in the multifunction
display:
Engine oil level
Measuring now!
Measurement
correct
only if veh. level
One of the following messages will
subsequently appear in the indicator:
ț Engine oil level
ok
ț Add 1.0 qt.
to reach max. oil level!
(Canada: 1.0 liter )
ț Add 1.5 qt.
to reach max. oil level!
(Canada: 1.5 liter )
ț Add 2.0 qt.
to reach max. oil level!
(Canada: 2.0 liter )
̈ If necessary, add engine oil.
For adding engine oil see ( ୴ page 291).
More information on engine oil can be
found in the “Technical data” section
(
୴ page 410) and ( ୴ page 412).
i
If you want to interrupt the checking
procedure, press the
k or j
button on the multifunction steering
wheel.