Mercedes-Benz 2004 CLK 500 - Manual (Page 146)

146
Controls in detail
Control system
With daytime running lamp mode se-
lected and the exterior lamp switch at
position 0, the following lamps will
come on automatically when the en-
gine is turned on:
ț Parking lamps and low beam head-
lamps
ț License plate lamps (in low ambient
light conditions)
Setting locator lighting
During darkness, the following lamps will
come on when the exterior lamp switch is
in position
U, the locator lighting fea-
ture is activated, and the vehicle is un-
locked by remote control:
ț Parking lamps
ț Tail lamps
ț License plate lamps
ț Front fog lamps
To activate locator lighting:
̈ Make sure the function surround light-
ing is set to
on , see ( ୴ page 146).
̈ Turn the exterior lamp switch to posi-
tion
U.
The locator lighting switches off when the
driver’s door is opened. It switches off au-
tomatically after a period of approximately
40 seconds.
̈ Move the selection marker with
the
æ or ç button to the
Light-
ning submenu.
̈ Press button j or k repeatedly
until you see this message in the dis-
play:
Function Surround lighting .
The selection marker is on the current
setting.
̈ Press æ or ç to select the de-
sired setting.
The locator lighting will be switched on
or off.
i
If you turn the exterior lamp switch to
another position, the corresponding
lamp(s) will switch on.
For safety reasons, resetting the
Lighting submenu to factory settings
( ୴ page 140) while driving will not re-
set the daytime running lamp mode.
In the display you will then see the mes-
sage:
Lighting – Cannot be com-
pletely reset to factory settings
while driving
.
୴୴