Monarch Instrument 9401 - Manual (Page 16)

8. Slide the supply guide to the top of the supply guide roller.
9. Remove the seal from the new roll of supplies.
10. Remove the first label from the backing paper.
11. Place the roll of supplies on the supply platter.
12. Feed the supply through the supply sensor, past the
printhead, and up to the feed mark (red line).
13. Slide the supply guide down the supply guide roller until it
just touches the edge of the supply strip.
14. Close the printhead by turning the printhead lever as
shown.
15. Close the printer cover.
Feed
Mark
Supply
Sensor
Printhead
Lever Supply
Guide
Supply
Guide
Roller
9401/9402 Equipment Manual
12