MITSUBISHI ELECTRIC CP800DW - Manual (Page 10)

9
PREPARATION
FEATURES
PRECAUTIONS
CONNECTIONS
OTHERS
TROUBLE- SHOOTING
CONNECTION WITH SCSI DATA SIGNAL EQUIPMENT
ID No.
SCSI ID switch
2
Setting SCSI ID switch
(CONNECTION)
SCREW
1 2 3 4 5 6 7 8
AC LINE
1 2 3 4 5 6 7 8
DIRECT SNAP
ACK
ON PARALLEL
OFF SCSI
ON
OFF
PARALLEL
ID No.
SCSI
To SCSI port
To SCSI port
Personal computer Digital Color printer
ID No. switch
Terminator
NOTE
When this unit is not connected to the other equipment through another SCSI port, make
sure to attach a terminator on the SCSI port which is not used. See the operation manual
of an equipment to be connected for attaching terminator.
Make sure to turn off main power of the unit and other equipment before connection.
Set the MODE switch No. 1 to OFF (SCSI).
Select the ID number among 1 to 6.
Turn the arrow to set the ID number with a screwdriver.
The default setting is No. 5.
No. 7 is provided for personal computer you use and No. 0 is provided for a built-in hard disk.
Do not set the ID number to the same setting as the connected equipment.
NOTE
Make sure to turn on the power again when SCSI ID number is changed with the power
turned on.
2
Setting ON LINE status
1 1 1 1 1
Press POWER button to turn on this unit.
The lamp over the POWER button is lit.
POWER