Philips Magnavox MRV700VR - Manual (Page 73)

Follow the steps below to copy a DVD to a videotape. This will be possi-
ble only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the tape’s
record tab is intact and the tape is long enough to record the DVD.
Advance the tape to the point at which you want to start recording.
● Put the DVD you want to copy in the disc tray. Advance it to the point
at which you want to start recording, then press STOP C.
● Press VCR so the VCR light appears on the front of the Recorder.
● Turn on the TV and set it to channel 3, 4, or its Video Input.
1 With the Recorder in VCR mode, press REC SPEED/MODE
until the desired tape speed (SP or SLP) appears briefly on
the screen.
Details about tape speed are on page 79.
2 Press DVD so the DVD light appears on the front of the
Recorder.
3 Press D.DUBBING on the front of the Recorder. The unit will
be in recording standby mode. REC will flash in the VCR display
panel.
4 Press D.DUBBING on the front of the Recorder again to
start recording.
The DVD will start playing automatically, and the
tape counter will show recording progress in the VCR display panel.
REC will appear on the VCR display panel.
5 To stop recording press VCR, then press STOP C .
DVD to Videotape Duplication 73
DVD ÞVCR Dubbing
DVD ➞VCR Dubbing
• You cannot copy a DVD to a
videotape if you are using
Progressive Scan.
Helpful Hint
3-4
1
5
2
E9490UD_EN.qx3 04.8.3 11:55 AM Page 73