McIntosh MA6600 - Manual (Page 18)

18
After approximately 3 seconds the Information Display
returns to indicate the Source Selection and Volume Level.
METER ILLUMINATION
The MA6600 Front Panel Meter Illumination may be
switched On or Off by performing the following:
1. Rotate the TRIM SELECT Control or press the TRIM
Push-button on the Remote Control until “METER”
appears on the Front Panel Information Display. Refer
to figure 34.
2. Rotate the
TRIM AD-
JUST Control
or press the
LEVEL + /
- Push-but-
tons to switch
On or Off the
Meter Illumi-
nation. Refer to figure 35.
After approximately 3 seconds the Information Display
returns to indicate the Source Selection and Volume Level.
Note: For information on how the Front Panel Information
Display Brightness can change with the Meter Illumi-
nation setting, refer to page 15 “Display Brigthness”.
Mono
Press the Front Panel MONO Push-button or the MODE
Push-button on the Remote Control to combine left and
right stereo signals to a Monophonic signal. The LED
After approxi-
mately 3 seconds
the Information
Display returns
to indicate the
Source Selection and Volume Level.
TRIM LEVEL
The Trim Level adjustments allow for making fine adjust-
ments to the previously performed Trim Level Adjustments
(refer to the Setup Section of this Owner’s Manual on page
13). To make fine adjustment to the currently selected
Input Source perform the following:
1. Rotate the TRIM SELECT Control or press the TRIM
Push-button on the Remote Control until “TRIM
LEVEL” appears on the Front Panel Information Dis-
play. Refer to
figure 31.
2. Rotate the
TRIM AD-
JUST Control
or press the
LEVEL + / -
Push-buttons
to adjust the
volume level
from -6dB to
(+) 6dB. Refer
to figures 32
and 33.
How to Operate the MA6600, con’t
Figure 33
TRIM LEVEL: 6.0 dB
Min Max ¦ ¦ ¦¦¦¦¦¦
Figure 32
TRIM LEVEL: -6.0 dB
Min Max ¦ ¦ ¦¦¦¦¦¦
Figure 31
TRIM LEVEL: 0.0 dB
Min Max ||
Figure 34
METER
LIGHTS: ON
Figure 35
METER
LIGHTS: OFF
TONE CONTROL
CD1 : BYPASS
Figure 30
SOURCE: CD1
15%
Figure 17