Memorex MLT2022 - Manual (Page 25)

TV OPERATION
24
Adjust the volume level by pressing the VOLUME
UP/Navigation Right 1 or VOLUME DOWN/Navigation Left
2
button. The volume level will be indicated on the screen
by a blue bar.
3
For proper operation, before selecting channels, they
must be set into the TV’s program memory, see page 22.
Press and release the CHANNEL/Navigation UP 1 or
DOWN 2 button. The TV automatically stops at the next
channel set into memory. This will not operate if channels
are not set into memory.
Direct Program Selection buttons (0-9) 3.
Use these buttons to select a channel. The channel number
will appear at the top right corner of the screen.
• For Channels 01 through 99, press the two digits in order.
• For Channels 100 through 125, press the 1-- button 4,
then the remaining two digits.
1
2
4
3
4
Set the AIR/CABLE (SYSTEM) option as described on
page 22.
2
Make sure the main power switch is on as shown on page
14, then press the POWER button 1 to turn on the TV; the
POWER indicator will light green. Press the TV/VIDEO
button 2 repeatedly to select the TV mode.
1
OPTIONS
AIR: If using a
VHF/UHF
antenna.
CATV: If using Cable
TV.
NOTES:
• When TV/CATV is set to TV, only channels up to 69
can be selected. When set to CATV, channels up to
125 can be selected.
• If an invalid channel is selected, the display will revert
to the original channel.
FAQs:
Why do I only receive 69 channels, when my cable goes much higher?
SYSTEM option must be set to CATV when using cable, see page 22.
Why are some channels scrambled?
You must subscribe to these channels through your cable company.