Onfiguration, Uide – Grandstream Networks GXW400x User Manual
Page 18
Grandstream Networks, Inc.
GXW-400x User Manual
Page 18 of 39
Firmware 1.0.0.39
Last Updated: 5/2007
C
ONFIGURATION
G
UIDE
C
ONFIGURING
GXW400
X
VIA
V
OICE
P
ROMPT
DHCP
M
ODE
Select voice menu option 01 to enable GXW400x to use DHCP.
STATIC
IP
M
ODE
Select voice menu option 01 to enable GXW400x to use STATIC IP mode, then use option 02, 03, 04, 05
to set up IP address, Subnet Mask, Gateway and DNS server respectively.
F
IRMWARE
S
ERVER
IP
A
DDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C
ONFIGURATION
S
ERVER
IP
A
DDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U
PGRADE
P
ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F
IRMWARE
U
PGRADE
M
ODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1)
always check, 2) check when pre/suffix changes, and 3) never upgrade
WAN
P
ORT
W
EB
A
CCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.
C
ONFIGURING
GXW400
X WITH
W
EB
B
ROWSER
GXW400x has an embedded Web server that will respond to HTTP GET/POST requests. It also has
embedded HTML pages that allow users to configure the GXW400x through a Web browser such as
Microsoft’s IE and AOL’s Netscape.
A
CCESS THE
W
EB
C
ONFIGURATION
M
ENU
The GXW400x HTML configuration menu can be accessed via LAN or WAN port:
From the LAN port:
1. Directly connect a computer to the LAN port.
2. Open a command window on the computer
3. Type in “ipconfig /release”, the IP address etc. becomes 0.
4. Type in “ipconfig /renew”, the computer gets an IP address in 192.168.2.x segment by default
5. Open a web browser, type in the default gateway IP address.
http://192.168.2.1
. You will see the
login page of the device.
From the WAN port:
The WAN port HTML configuration option is disabled by default from factory. To access the HTML
configuration menu from the WAN port:
1. Enable the “WAN Port Web Access” option via IVR option 12.