Grizzly FOOT SHEAR T23036 - Manual (Page 25)

t23036 37" Foot Shear
-23-
Tools Required Qty.
Socket or Wrench 17mm ....................................1
the blades can be removed by removing the hex
bolts that attach the blades to the castings (see
Figure 29).
the moving blade has two cutting edges that are
ground with a 2° edge relief. reverse the blade
to expose the new cutting edge as soon as one
edge is dull. the blade can be sharpened on a
surface grinder by grinding both wide sides of the
blade.
the fixed blade has one cutting edge with a
2° edge relief and a 1° face relief. it can be
resharpened on a surface grinder by grinding the
wide side of the blade.
blade Sharpening/
Replacement
Figure 29. top blade bolts (typical foot shear
shown).
Blade hex Bolts
After new blades are installed or old blades are
sharpened, they must be adjusted. proceed to
blade Adjustment on page 16.