Genicom microLaser 170 - Manual (Page 56)

Ze
b
ra
Xi
II P
ri
n
te
r U
se
r’s
Gu
id
e
4
3
O
per
ati
o
n
F O R M A T P R E F I X
Format Prefix Character Press the left oval key to move to the next digit position, press the
right oval key to increase the value of the digit.
Default: 5E (caret) Range: 00 - FF (Exclude the values indicated on the ASCII Code Chart in
the Appendix.)
The printer looks for this 2-digit hex character to indicate the start of a ZPL/ZPL II format instruc-
tion.
D E L I M I T E R C H A R
Delimiter Character Press the left oval key to move to the next digit position, press the right
oval key to increase the value of the digit.
Default: 2C (comma) Range: 00 - FF
The Delimiter character is a 2-digit hex value used as a parameter place marker in ZPL/ZPL II for-
mat instructions. Refer to the ZPL II Programming Guide for more information.
Selecting ZPL Mode
Z P L M O D E
Selecting ZPL Mode Press the right or left oval key to display other choices.
Default: ZPL II Selections: ZPL II, ZPL
The printer will remain in the selected mode until it is changed by this front panel instruction or by
using a ZPL/ZPL II command. The printer accepts label formats written in either ZPL or ZPL II .
This eliminates the need to rewrite any ZPL formats you already have. Refer to the ZPL II Pro-
gramming Guide for more information on the differences between ZPL and ZPL II .
xi2ch2
Page 4
3
Tuesda
y
, Apr
il
23,
1996
1:
45
PM