Genicom microLaser 170 - Manual (Page 46)

Zebra XiII Printer User’s Guide 33
Operation
described below. Pressing the left or right black oval key displays other
choices and pressing the Next/Save key selects the displayed choice.
• PERMANENT - permanently saves the changes. Values are stored in the
printer even when power is turned off.
• TEMPORARY - saves the changes until changed again or until power is
turned off.
• CANCEL - cancels all changes since pressing the Setup/Exit key except
the Darkness and Tear-Off settings (if they were changed).
• LOAD DEFAULTS - loads factory defaults. The factory defaults are shown
on the following pages.
Note: Loading factory defaults will require Calibration and resetting the Head
Resistor value.
• LOAD LAST SAVE - loads values from the last Permanent Save.
xi2ch2 Page 33 Tuesday, April 23, 1996 1:45 PM