beautypg.com

Installation instructions – GE TRIVECTION JT980 User Manual

Page 5

background image

Installation Instructions

WALL MOUNT—SINGLE BUILT-IN OVEN
BELOW AN ADVANTIUM OVEN OPTION

When installed over a single wall oven,

allow at least 2” between the two openings.
This separation will provide clearance for
bottom overlap of the Advantium oven and
top overlap of the single wall oven.

If you are replacing a GE/Monogram electric

double oven with the combined installation
of an Advantium and single wall oven, the
middle rail separating the two openings
may need to be larger than the 2” min.
shown.

Always maintain 36 3/4” min. distance from

the floor to the Advantium oven cutout in
any installation combination.

When installed in combination with a

GE/Monogram single wall oven, use
separate electrical junction boxes.

Refer to Advantium oven installation

instructions for electrical requirements and
installation details of that product.

Advantium ovens are approved for

installation above only certain specified
wall oven models. See the label attached
to the top of the oven for approved
Advantium oven models.

B

WALL MOUNT—SINGLE BUILT-IN OVEN
ABOVE A WARMING DRAWER OPTION

A 2” min. clearance between oven and

warming drawer cutouts is required.

Additional clearance may be required if

2 x 4 blocks are used to support the solid
floor of the oven above. Check to be sure
that oven supports above the Warming
Drawer location do not obstruct the
required interior depth and height.

Refer to warming drawer installation

instructions for electrical requirements and
installation details of that product.

Warming drawers are approved for

installation below only certain specified
wall oven models. See the label attached to
the top of the oven for approved warming
drawer models.

C

24”

Min.

Construct
solid bottom
min. 3/8”
plywood
supported
by 2 x 4 or 1
x 2 runners,
all four sides

30”

2” Min.

Advantium

cutout

Oven

cutout

23 1/2” Min.

inside

Bottom of warming drawer must be 1”
above toekick

2” Min.

Warming

drawer cutout

Oven

cutout

A

Construct
solid bottom
min. 3/8”
plywood

NOTE: A single wall oven can be installed in
combination with the Advantium oven above
and a warming drawer below as long as the
dimensions and information on this page are
applied to the combination installation.

5

This manual is related to the following products: