GE TRIVECTION JT980 - Manual (Page 15)

15
Installation Instructions
FINAL CHECKLISTS
PRE-TEST CHECKLIST
Remove all protective film.
Check to be sure that all wiring is
secure and not pinched or in contact
with moving parts.
Check that the bottom trim is installed
properly (see Steps 11 and 12).
Check to be sure the mounting screws
are installed and flush with the side trim
(see Steps 9 and 10). D
C
B
A
14 OPERATION CHECKLIST
Remove all items from the inside of the
oven.
Check that conduit is securely connected
to the junction box.
Turn on the power to the oven. (Refer
to your Owner’s Manual.) Verify that the
bake and broil functions make the oven
hot. Verify by feeling heat coming off the
elements within 20 seconds.
See your Owner’s Manual for
troubleshooting list.
NOTE TO ELECTRICIAN:
The power leads supplied with this appliance
are UL recognized for connections to larger
gauge household wiring. The insulation of
these leads is rated at temperatures much
higher than the temperature rating of
household wiring. The current carrying
capacity of a conductor is governed by the
wire gauge and also the temperature rating
of the insulation around the wire.
NOTE: ALUMINUM WIRING
WARNING:
IMPROPER
CONNECTION OF ALUMINUM HOUSE
WIRING TO THE COPPER LEADS CAN
RESULT IN AN ELECTRICAL HAZARD
OR FIRE.
Splice copper wires to aluminum wiring
using special connectors designed and
UL approved for joining copper to
aluminum, and follow the manufacturer’s
recommended connector procedure
closely.
NOTE: Wire used, location and enclosure
of splices, etc., must conform to good
wiring practice and local codes.
B
A
D
C
B
A
15