beautypg.com

Transferring mapsource data – Garmin 110 User Manual

Page 90

background image

84

Rino

®

110 Owner’s Manual

A

PPENDIX

>

T

RANSFERRING

M

AP

S

OURCE

D

ATA

Transferring MapSource Data

If you have purchased a Garmin MapSource CD-ROM

mapping program, you may want to transfer detailed data

before beginning use to provide your unit with maximum

Find features. The Rino 110 accepts up to 1 MB of map

data from the MapSource Points of Interest. It is not

possible to transfer 3rd party maps into Garmin products.
Map data transfer requires the use of a PC, a Garmin

MapSource CD-ROM, and the PC Interface Cable with

RS-232 serial port connector supplied with this unit.

Follow detailed instructions for data transfer in the

MapSource User’s Manual.

To setup for data transfer:

1. Remove weather cap from the Power/Data Port

on the back of the unit by lifting up on the rubber

weather cap.

2. Connect the serial port connector on the cable to

an available serial port on your computer.

3. Connect the remaining cable connector to the

back of the Rino 110 by orienting the slot on the

connector with the indexing bar on the back of the

unit and push the connector until it is fully seated

in the unit.

4. Turn on the Rino 110 and follow instructions for

map data transfer provided in the MapSource

User’s Manual. See also the “Interface Setup

Page” section for unit interface settings.

This manual is related to the following products: