beautypg.com

Installing/removing morse taper sleeves – Grizzly G0517g User Manual

Page 18

background image

-16-

Model G0517 Mill/Drill

Installing/Removing

Morse Taper Sleeves

The Model G0517 includes an MT#1/#2 sleeve
and an MT#2/#3 sleeve. Always DISCONNECT
MACHINE FROM POWER when installing or
removing tooling.

To install a sleeve:

1. Make sure the spindle and sleeve tapers are

clean and free of any debris or grease.

2. Insert the sleeve into the spindle with the

tang side up (

Figure 19) and rotate with

upward pressure until it fits into place.

To remove a sleeve:

1. Lower the quill with the downfeed handle

and lock it in place with the quill lock (

Figure

21).

3. Using a rubber mallet or brass hammer (do

not use steel), tap the sleeve up into the
spindle to lock it in place (

Figure 20).

Figure 19. Installing a morse taper sleeve.

Figure 20. Tapping the sleeve into the spindle.

2. Insert the drift key into the quill slot as shown

in

Figure 22.

Figure 21. Location of quill lock.

Quill Lock

3. Hold the sleeve with one hand and gently

tap the drift key with a hammer to knock the
sleeve out.

Figure 22. Drift key inserted in quill slot.

Drift Key