Grizzly G0517g - Manual (Page 15)

Model G0517 Mill/Drill
-13-
Congratulations, your mill/drill is now assembled.
For further information about installing the drill
chuck or spindle sleeves, refer to the
Operations
section after performing the Test Run.
5. With the help of an assistant, place the mill/
drill headstock onto the column, as shown in
Figure 10.
Figure 10. Headstock installed on base column.
6. Center the headstock over the table and
tighten the lock handle shown in Figure 11.
Figure 11. Securing headstock to column.
8. Thread the ball knobs onto one end of the
downfeed handle shafts (the knobs go on the
end of the shaft with the shorter threads).
9. Thread the downfeed handle shaft assem-
blies into the pinion hub ( Figure 13).
Figure 13. Downfeed handles installed.
7. Thread the handwheel handles into the
handwheels, as shown in Figure 12.
Figure 12. Installing handwheel handles.
Lock Handle
Pinion Hub