Carbide cutters lubrication v-belts – Grizzly G0526 User Manual

Page 31

Text mode
Original mode

G0526 6" Jointer

-29-

To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition (free from cracks, fraying and wear).
Check the V-belt at least every 3 months; more
often if the jointer is used daily.

The carbide cutters are typically rotated at the
same time when they become dull; however, the
cutters can also be rotated individually when one
becomes nicked or damaged. Refer to

Section 8:

Service Adjustments

for instructions on rotating

or replacing the carbide cutters

Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.

Table ways and the fence assembly should not
be lubricated. If the tables appear to be stuck, dis-
assemble and clean any foreign materials from
the ways. Re-assemble and reset the gibs.

Carbide Cutters

Lubrication

V-Belts