GIGABYTE GA-M61PME-S2P - Manual (Page 68)

GA-M61PME-S2P Motherboard - 68 -
Step 6:
After assigning the RAID drives, press . A message which says "Clear disk data?" appears
(Figure 6). Press to confirm or press to cancel. (If the hard drives contain a previously created
RAID array, you need to press to clear the data in the hard drives.)
Figure 6
Figure 5
Step 5:
Next, select the hard drives which you wish to be included in the disk array. The Free Disks block
displays the information about the SATA hard drives that are available for use as RAID array drives.
Press to move to the Free Disks block. Select the target hard drives using the up or down arrow
key and use the right arrow key to add the hard drives to the Array Disks block (Figure 5).
MediaShield Utility Nov 20 2006
- Define a New Array -
RAID Mode: Striping Striping Block: Optimal
[
    ] Add
[     ] Del
[ESC] Quit [F6] Back [F7] Finish [TAB] Navigate [     ] Select [ENTER] Popup
1.0 ST3120026AS 111.79GB
1.1 ST3120026AS 111.79GB
Free Disks
Port
Disk Model Capacity
Array Disks
Port
Disk Model Capacity
Clear disk data ?
[Y] YES [N] NO
RAID Mode: Striping Striping Block: Optimal
[
    ] Add
[     ] Del
[ESC] Quit [F6] Back [F7] Finish [TAB] Navigate [
    ] Select [ENTER] Popup
1.0.M ST3120026AS 111.79GB
1.1.M ST3120026AS 111.79GB
MediaShield Utility Nov 20 2006
- Define a New Array -
Array Disks
Port
Disk Model Capacity
Free Disks
Port
Disk Model Capacity
Clear disk data?
[Y] YES [N] NO