GIGABYTE GA-M61PME-S2P - Manual (Page 43)

- 43 - BIOS Setup
(Note) Supported on Windows ® Vista ® operating system only.
USB Resume from Suspend
Allows the system to be awakened from ACPI S3 sleep state by a wake-up signal from the
installed USB device. (Default: Enabled)
Power-On by Alarm
Determines whether to power on the system at a desired time. (Default: Disabled)
If enabled, set the date and time as following:
Day of Month Alarm: Turn on the system at a specific time on each day or on a specific day
in a month.
Time (hh: mm: ss) Alarm: Set the time at which the system will be powered on automatically.
Note: When using this function, avoid inadequate shutdown from the operating system or removal
of the AC power, or the settings may not be effective.
HPET Support (Note)
Enables or disables High Precision Event Timer (HPET) for Windows ® Vista ® operating system.
(Default: Enabled)
HPET Mode (Note)
Allows you to select the HPET mode for your Windows ® Vista ® operating system. Select 32-bit
mode when you install 32-bit Windows ® Vista ® ; select 64-bit mode when you install 64-bit
Windows ® Vista ® . (Default: 32-bit mode)
Power On By Mouse
Allows the system to be turned on by a PS/2 mouse wake-up event.
Note: To use this function, you need an ATX power supply providing at least 1A on the 5VSB lead.
Disabled Disables this function. (Default)
Double Click Double click on left button on the PS/2 mouse to turn on the system.
Power On By Keyboard
Allows the system to be turned on by a PS/2 keyboard wake-up event.
Note: you need an ATX power supply providing at least 1A on the 5VSB lead.
Disabled Disables this function. (Default)
Password Set a password with 1~5 characters to turn on the system.
Any KEY Press any key on the keyboard to turn on the system.
Keyboard 98 Press POWER button on the Windows 98 keyboard to turn on the system.
KB Power ON Password
Set the password when Power On by Keyboard is set to Password. Press on this item
and set a password with up to 5 characters and then press to accept. To turn on the
system, enter the password and press .
Note: To cancel the password, press on this item. When prompted for the password, press
again without entering the password to clear the password settings.
AC Back Function
Determines the state of the system after the return of power from an AC power loss.
Soft-Off The system stays off upon the return of the AC power. (Default)
Full-On The system is turned on upon the return of the AC power.