Grizzly G9749 - Manual (Page 17)

G9749 Variable Speed Drill Press
-15-
Assembly
Components and Hardware Needed: Qty
Hex Wrench 5mm (provided) ............................ 1
Rapid Downfeed Handle Shafts ........................ 3
Rapid Downfeed Handle Knobs ........................ 3
Table Crank Knob ............................................. 1
Open End Wrench
9 ⁄
16
" ...................................... 1
To install the rapid downfeed handles:
1. Screw each knob onto the shaft end with the
longest thread pattern.
2. Screw the resulting handle assembly into the
threaded holes on the rapid downfeed control
base (see
Figure 10).
3. Use a 9 ⁄
16
" wrench to tighten the shaft to the
control base.
To install the table crank handle:
1. Screw the table crank handle into the thread-
ed hole on the table crank (see Figure 11).
Figure 10. Rapid downfeed handles installed in
control base.
Figure 11. Table crank handle installed.
2. Use a 5mm hex wrench (provided) to tighten
the set screw in the end of the handle.
Knob
Shaft
Control
Base
Set Screw
Table Crank
Handle