Grizzly Extreme Series Jointer G9953ZXF - Manual (Page 45)

Extreme series Jointer (Mfg. since 9/11)
-43-
Figure 67. Fence tilting controls.
tilt lock
45° stop
90° stop
3. place the machinist's square flat on the
outfeed table fairly close to the cutterhead,
as shown in
Figure 65, adjust the fence to
the square, then tighten the fence tilt lock to
secure the setting.
4. tighten the stop bolt toward the fence assem-
bly until it becomes snug, then re-tighten the
jam nut.
Models G9953, G9953ZX, G9953ZXF
Tools Needed Qty
Machinist's square ............................................ 1
Bevel square ..................................................... 1
Wrench 10mm ................................................... 1
To set the 90° fence stop:
1. disCoNNECt JoiNtEr FroM poWEr!
2. loosen the tilt lock and the 90° stop jam nut,
then back off the stop bolt (see Figure 67).
To set the 45° fence stop:
1. disCoNNECt JoiNtEr FroM poWEr!
2. loosen the tilt lock and the 45° stop jam nut,
then back off the stop bolt (see Figure 67).
3. place the bevel square set at 135° flat against
the outfeed table close to the cutterhead, as
shown in
Figure 66, adjust the fence to
match the angled face of the square, then re-
tighten the tilt lock.
4. tighten the stop bolt toward the fence assem-
bly until it becomes snug, then re-tighten the
jam nut.