GE IM4A - Manual (Page 28)

• Fasten the water valve to the cabinet edge hole
with the hex-head screw (10) from the kit.
DO NOT DRILL ANY ADDITIONAL HOLES.
28
Installation Instructions
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug
the Refrigerator. To eliminate the danger
of electric shock during installation, you
must unplug the refrigerator from its
electrical outlet.
WATER VALVE ASSEMBLY INSTALLATION INSTRUCTIONS Q
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator —
or S R Q P N M L
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
1/4
″ and 5/16″ Nutdrivers
ATTACH THE WATER VALVE
• Locate the female connector plug (C). Plug
the female connector (C) onto the male terminals
on the water valve (3). Either wire can go on either
terminal.
2
CUT PLASTIC WATER TUBING
• Measure 65
″ (165 cm) of water tubing starting
from where it is secured to the water valve. Cut
off excess tubing with a sharp knife or single-edge
razor blade.
1
10
C
3
65 ″
(165 cm)
Tape measure