GE IM4A - Manual (Page 15)

15
Installation Instructions
10
8
INSTALL THE ICE BUCKET
Place the ice bucket (9) under the icemaker.
Make sure the icemaker power switch
is in the OFF position.
11
9
ATTACH WARRANTY LABEL
A label (7) is provided with this kit to record the date of
installation for warranty purposes. Apply it to the back
of the refrigerator.
12
KEEP THIS MANUAL
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner’s Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section.
13
D
MOUNT THE ICEMAKER
• Lift the icemaker so the fill tube (13) or fill tube
extension (8) (depending on model) fits in the fill
cup opening (D). Hang the icemaker on the two
mounting screws (B).
Make sure:
• The power cord is still firmly in the socket.
• The fill tube (13) or fill tube extension (8)
extends into the fill cup opening at the back
of the icemaker. (Check the rear of the refrigerator
to make sure the fill tube has not been pushed out
of the back of the refrigerator).
• The icemaker mounting screws are located
in the uppermost position of the mounting slots.
• The icemaker is level.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
B
INSTALL FILL TUBE EXTENSION
For models with one temperature control
(refrigerator) only:
• Cut the fill tube extension (8) to the
length
(refer to the template on page 42) with a sharp
knife or a single-edge razor blade and slide it onto
the fill tube against the stop.
M
M
6
M 8
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply
to prevent premature operation.
7
Power
Switch
INSTALL THE ICEMAKER FILL CUP
Install the icemaker fill cup (side-mounted) (15)
into the icemaker as shown.
8
15
PLUG IN THE ICEMAKER
Holding the icemaker in
place, insert the icemaker
power cord plug into the
socket on the side or rear
wall (depending on model),
making sure the prongs
and holes are matched.
Press the plug firmly into
the socket. Lock the plug
in place by clipping
the restraints onto each side of the plug. Make sure
the restraints click into place. Make sure the power
cord is still in the hook on the back of the icemaker.
9
Hook
13 or
(Appearance may vary)