Genie GTH-1056 - Manual (Page 43)

OPERATION
SWAY C ONTROL
PU MP OFF
BR AKE ON
(C) L ET TE R VISIBLE = 3,000 LBS
(D) L ET TE R VISIBL E = 2,000 L BS
P /N 3-1483 0
(1. 22)
ME TE R FE ET (6. 10) 28 (8.54) 24 (7. 32) 20
4
!"#"$ & ' ()*"#+
455 NORTH SUPE RIOR AVENUE
MACHINE ON A FIRM, LE VEL
SURFACE WIT H U NDAMAGED ,
PROPE RL Y IN FLAT ED CALCIUM
CAPACIT Y IS PER ANSI B56.6
L OAD L IMITS / HORIZO NTAL BOOM
(B) L ET TE R VISIBLE = 4,000 LBS
O R OPT IONAL FOAM FILL ED TIRES. CHLORIDE SO LUT ION FIL LE D T IRE S
RATE D L IFT CAPACITIE S ARE WITH :
L AST FU LL Y VISIBLE L ET TE R (A) L ET TE R VISIBLE = 6, 000 LBS RE TRACT ED = 8, 000 L BS
RE AR AXL E LOCK-UP EN GAGED.
(. 61 MET ERS) LOAD CENT ER W IT H
MANUF ACTURE R'S RECOMME NDED ST ABILIT Y T EST S U SING ST ANDARD (1.22x1.22x1.22 ME TE RS ). L OAD HOMOG ENE OUS CU BE S 4x4x4 FT.
P .O. BOX 790 P HONE 906-353-6675
F AX 906-353-7543
CAPA CIT IES AT 24 INCH S TANDA RD FORK FRAME .
BARAGA , M ICHIGA N 49908
12 (3.66) 16
(14. 64) 48 ME TE R FE ET (6. 10) 28 (8.54) 24 (7. 32) 20
32
20
24 (7. 32)
(8. 54) 28 (9. 76)
44 (13. 42) 40
36 (10. 98)
(12. 20)
0
(4. 88)
(4. 88) 12 (3.66) 8 16 (6.10) 20 4 (1. 22) (2.44)
(4. 88) 12 (3.66) 16 (6.10) 20
HEATER HEADLIGHT LEFT STABILIZER RIGHT STABILIZER
BLIN
ENGINE
BRAKE ON
SWAY CONTROL
PUMP OFF
HEATER HEADLIGHT LEFT STABILIZER RIGHT STABILI ZER
BLIN
ENGINE
DANGER
If the machine should start with the transmission control lever
(C) in gear, stop operation at once or property damage, serious
injury or death may occur. Have a qualified service technician
repair the machine.
DANGER
NEVER attempt to start the machine without being seated in
the operator's compartment, the parking brake (B) in the on
position and the transmission control (C) in the neutral
position. Attempting to start the machine from outside the
operator's compartment may result in property damage, serious
injury or death.
DANGER
Any problems discovered in the steps prior to "BEFORE
STARTING ENGINE" should be corrected before the machine
is started.
STARTING THE ENGINE
4 - 5
Insert the ignition key in the ignition switch (D). Rotate the key
clockwise until the engine starts. Release the key when the
engine starts.
B
C
D