Genie GTH-1056 - Manual (Page 33)

CONTROLS AND INSTRUMENTS
BRAKE ON
SWAY CONTROL
PUMP OFF
HEATER HEADLIGHT LEFT STABILIZER RIGHT STABILIZER
BLIN
ENGINE
The transmission control (C) has one lever that controls both
directional and speed requirements. It is located on the left side
of the steering column.
To shift into Forward gear gently pull the lever toward you and
move the lever upward.
To shift into Neutral move the lever to the center position.
To shift into Reverse gear gently pull the lever toward you and
move the lever downward.
To shift into a lower speed rotate the lever clockwise.
To shift into a higher speed rotate the lever counter-clockwise.
When shifting the transmission from forward to reverse while
the machine is in motion the transmission control (C) must be
in 1st or 2nd gear only.
Forward / 1st Low speed/High torque
Forward / 2nd Medium speed/Medium torque
Forward / 3rd High speed/Low torque
BRAKE ON
SWAY CONTROL
PUMP OFF
HEATER HEADLIGHT LEFT STABILIZER RIGHT STABILIZER
BLIN
ENGINE
In addition to the steering wheel, the machine has another
steering control, the steering selector switch.
The steering selector switch (B) is a three-position switch.
The three positions are: 4-wheel, 2-wheel , and oblique.
Switch positions are selected and function as follows:
4-WHEEL Handle right of center
2-WHEEL Handle directly centered
OBLIQUE (CRAB) Handle left of center
CAUTION
Before changing steering selections, make sure all four wheels
are in line. Failure to align the wheels to the proper settings
before changing steering positions may cause haphazard steering.
This may result in injury to personnel and/or damage to the
machine or property.
B
C
STEERING
TRANSMISSION
3 - 9