GE WBVH6240 - Manual (Page 55)

– 55 –
Error Code Description Problem Possible Cause/Action
E4E Under volts after
start Initial minimum
voltage not
received
- motor does
not run. DC bus
(inverter). Check Motor - t10 tumble, t11 spin, t14 spin.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
•
•
E4F EEProm fault EEProm reading
error occurs. Non-recoverable error.
Replace inverter control board.
•
•
E52 Main control
wake-up error Lost
communication
between
control and
drive motor
after initial
success. Check Motor - t10 tumble, t11 spin, t14 spin.
Check connections/cables between main control
and inverter.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
Main control board can cause code in limited
circumstances, as loose plug on board.
•
•
•
•
E53 Buffer error Internal
software buffer
error. Check Motor - t10 tumble, t11 spin, t14 spin.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
•
•
E54 No motor
response Lost
communication
between
control and
drive motor. Check Motor - t10 tumble, t11 spin, t14 spin.
Check connections/cables between controls.
Power down (unplug) washer, wait 30 seconds and
retry - if reoccurs, replace inverter.
•
•
•
E57 Checksum failure Software
error occurs
- checksum
failure.
Non-recoverable error.
Main control board must be replaced.
•
•
E58 Communication
failure Communication
error occurs. Non-recoverable error.
Main control board must be replaced.
•
•
E60 Door lock switch
failure Switch failure
occurs during
lock. Power down (unplug) machine, wait 30 seconds and
retry.
Check wiring and connections between door lock
and main control.
Check door lock switches and solenoid.
Replace main control if wiring, switches, and
solenoid test functional.
•
•
•
•
(Continued Next Page)