GE WBVH6240 - Manual (Page 42)

– 42 –
Note: The threaded plate can fall out of the
recessed slot in the motor mount. Ensure this plate
is reinserted in the slot upon reassembly.
Note: When reinstalling bolt, apply Locktite (Part #
WX5X1005) to bolt threads. Ensure motor arm is at
lowest position under motor bolt before tightening.
Rock motor rearward to clear the motor mounts
from the outer tub. Place the motor on the
washer chassis.
Disconnect the motor wire harness.
Press the lock tab and remove the motor ground
wire.
Remove the plastic wire tie that holds the motor
wire harness and ground wire to the motor.
Remove the motor.
Note: When reinstalling the belt, ensure the belt
is positioned to track in the 7 outer grooves of the
motor pulley.
5.
6.
7.
8.
9.
Door
To remove the door components:
Remove the 4 Phillips-head screws that hold the
hinge cover to the door. Lift the hinge cover from
the door. 1.
Remove the 2 Phillips-head screws that hold the
door to the hinge door plate. 2.
(Continued Next Page)