GE WBVH6240 - Manual (Page 53)

– 53 –
Error Code Description Problem Possible Cause/Action
E22 Fill timeout - No
fi ll/slow fi ll Fill time exceeds
8 minutes. Ensure manual water supply valves are fully open.
Inspect inlet hoses for kinks/obstructions.
Inspect water valve screens for restriction.
Check water valve functions - t08 for hot water, t09
for cold water.
If above steps do not clear the problem replace solenoid
water valve.
•
•
•
•
E23 Flood protect
drain F o a m s w i t c h
closes in idle
state. Check water valve functions - t08 for hot water, t09
for cold water.
Check pressure switch foam contacts - t06 - fi rst
display should be E.
Off balance loads with heavy vibration can cause
code - retry before replacing any component.
•
•
•
E30 Drain pump not
present Drain problems
- no electrical
signal from
drain pump. Check drain pump - t05.
Check drain pump motor for open.
Check power to drain pump.
Check drain pump for stalling.
•
•
•
•
E31 Drain timeout Slow drain
- machine will
have water
- not full. Check drain pump - t05.
Check drain pump for restriction.
Check for drain restriction.
Drain height over 96-in. can cause code.
•
•
•
•
E38 Dispenser error Correct
reservoir is not
found and 8
switches are
seen when
motor is
running. Check dispenser - t12 (Note: Do not unplug
connectors from dispenser motor unless replacing.) •
E39 Dispenser timeout No switches
found in 45
seconds. Check dispenser - t12 (Note: Do not unplug
connectors from dispenser motor unless replacing.) •
E42 Drive motor
- instantaneous
current Motor excess
current draw. Check drive motor - t10 tumble, t11 spin, t14 spin.
Power down (unplug) washer, wait 30 seconds and
retry. If code reoccurs, check drive motor windings.
If motor windings OK, replace inverter. (You may see
a burned spot on inverter.) (Note: Cannot occur with
open motor winding.)
•
•
Error Codes
(Continued Next Page)