Genie SUPERLIFT 97550 - Manual (Page 6)

4 Genie Superlift Advantage Part No. 97550
Operator's Manual Third Edition • Third Printing
SAFETY RULES
Crushing Hazards
Do not raise if the load is not properly centered on
the load handling attachment.
Do not raise unless the load is properly secured to
the load handling attachment.
Do not stand under or
allow personnel under
the machine when the
load is raised.
Do not stand under the
load. The safety brake
system (if equipped) will
allow the load to drop 1
to 3 feet / 30 to 92 cm
before locking the columns.
Do not lower the load unless the area below is clear
of personnel and obstructions.
Keep hands and fingers away from folding legs and
other potential pinch points.
Maintain a firm grasp on the stabilizer when the
lock plates are released. The stabilizer will drop.
Maintain a firm grasp on the leg when the retaining
pin is removed. The leg will drop.
Maintain a firm grasp on the winch handles until the
brake is locked. The brake is locked when the load
will not cause the winch handles to turn.
Adjustable Flat Forks
Do not raise the load unless the
snap pins are properly inserted
in the forks.
Fork Extensions
Do not raise the load unless the fork extensions are
properly secured to the forks.
Collision Hazards
Check the work area for
overhead obstructions or
other possible hazards.
Do not tilt the machine
back unless the area is
clear of personnel and
obstructions.
Use common sense and planning when transporting
the machine on an incline or slope.
Do not load for transport unless the machine and
vehicle are on a level surface. Use proper lifting
techniques to load the machine.