Gateway 960 - Manual (Page 70)

65
Replacing the system board
www.gateway.com
Replacing the system board
To replace the system board:
1
Follow the instructions in “Preventing static electricity discharge” on
page 27 .
2
Follow the instructions in “Opening the server case” on page 28 .
3
Remove the memory modules. For more information, follow the
instructions in
“Installing memory” on page 44 .
4
Remove all of the expansion cards. For more information, follow the
instructions in
“Installing PCI expansion cards” on page 46 .
5
Remove the heat sinks and processors. For more information, follow the
instructions in
“Installing a processor” on page 51 .
6
If your new system board does not include heat sink mounting brackets,
remove the heat sink brackets from your old system board by removing
the eight screws that secure them to the board.
7
Remove the voltage regulators. For more information, follow the
instructions in
“Installing a voltage regulator” on page 55 .
8
Disconnect the power, data, and fan cables from the system board, noting
their locations and orientation. (You will reconnect the cables after you
install the new board.)
9
Remove the rear fan to provide more space for removing the system board.
For more information, see
“Replacing a fan” on page 68 .