Gateway 960 - Manual (Page 64)

59
Replacing the SCSI backplane
www.gateway.com
Replacing the SCSI backplane
Your server’s hot-swap cage can hold four SCSI drives. The cage is connected
to a SCSI backplane.
To replace the SCSI backplane:
1
Follow the instructions in “Preventing static electricity discharge” on
page 27 .
2
Follow the instructions in “Opening the server case” on page 28 .
3
Remove the fan nearest the SCSI backplane. For instructions, see
“Replacing a fan” on page 68 .
4
Remove each of the drives from the hot-swap cage, noting the location of
each drive. For instructions, see
“Installing a SCSI hard drive” on page 41 .
5
Loosen the four captive thumbscrews on the front of the hot-swap cage.
Thumb-
screws
Thumb-
screws