beautypg.com

Garmin GPSMAP 2108 User Manual

Page 52

background image

48

GPSMAP

®

2008/2108 Owner’s Manual

a

ppendix

the unit. Contact your dealer or Garmin Product

Support to have the unit serviced.
sonar service lost—the external sonar device you

were connected to has either been disconnected or the

unit has lost communication with the sonar device for

some other reason.
Tornado Warning*—a tornado warning was issued

for the area by the National Weather Service.
Track Already Exists [Track Name]—you entered

a saved track name that already exists in memory.

Modify the track name or delete the existing track.
Track log Full—the track log is full and track

recording has been turned off. To record more track

points, you need to clear the track log and turn track

recording on. This only appears when the track

recording setting is set to “Stop When Full.”
Track Memory is Full, Can’t Create Track—the

track log memory is full. No additional track log

data can be stored without deleting old data to create

memory space.
Track Truncated—a complete uploaded track does

not fit into memory. The oldest track log points were

deleted to make space for the most recent data.

Transducer Disconnected, sonar Turned

Off—there is not a transducer attached, bad cable/

transducer, or the transducer cable was disconnected.

If the transducer cable is removed while the unit is on,

reconnect and cycle power.
Transfer Complete—the unit has finished uploading

or downloading information to the connected device.
user Card Not Found, Please Insert Card

attempted to transfer user data without an SD card

containing user data being present in the SD card slot.
Water speed sensor Is Not Working—the speed

sensor is not detected. Check the connections.
Water Temperature Alarm—sonar has reported

a temperature above, below, inside, or outside the

specified value(s).
Waypoint Already Exists—you entered a waypoint

name that already exists in memory. Modify the

waypoint name or delete the existing waypoint.
Waypoint Memory Full—you have used all 1,500

waypoints available. Delete unwanted waypoints to

make space for new entries.

This manual is related to the following products: