beautypg.com

Garmin GPSMAP 2108 User Manual

Page 50

background image

46

GPSMAP

®

2008/2108 Owner’s Manual

a

ppendix

this message appears.
battery Alarm—battery voltage has fallen below the

value entered in the Battery Alarm setup.
battery Voltage Is Too high—too much input

voltage; the unit shuts off in 10 seconds. Decrease the

input voltage to 35 Volts or less.
boat Is Not Moving Fast Enough to Calibrate—the

boat is not moving fast enough for the speed wheel to

provide a valid speed.
Can’t Read user Card—error reading card; remove

and reinsert. Contact your dealer or Garmin Product

Support if the problem persists.
Can’t Read Voltages That high, limited To Top Of

Range—the voltage value in the Battery Alarm setup

is higher than the unit can read.
Can’t Read Voltages That low, limited To bottom

Of

Range—voltage value in the Battery Alarm setup is

lower than the voltage where the unit automatically

turns off.
Can’t unlock Maps—data on data card is not

unlocked for the unit. Contact your dealer or Garmin

Product Support.
Can’t Write user Card, Card May be Full—error

reading card; remove and reinsert. Contact your dealer

or Garmin Product Support if the problem persists.
Can’t Write user Card, Card Is Read-Only—the

SD card in your unit contains data copy protection.
DsC Position Report Received From—shows the

MMSI or name associated with an MMSI.
Database Error—internal problem with the unit.

Contact your dealer or Garmin Product Support to

have the unit serviced.
Deep Water Alarm—the Deep Water Alarm depth

has been reached.
Directory Item With This MMsI Already Exists

the MMSI number is already in DSC directory. Use a

different number.
Directory Memory is Full, Can’t Create Entry

the DSC directory has reached maximum of 100

contacts. Delete unneeded contacts to add new ones.
Distress Call—a DSC distress call has been received.

Take appropriate action.
Entering (leaving) target water temperature—the

This manual is related to the following products: