Configuring system settings, Changing units of measure – Garmin GPSMAP 2108 User Manual
Page 29

GPSMAP
®
2008/2108 Owner’s Manual
25
C
onfigUring
The
U
niT
C
onfiGUrinG
The
U
niT
Use the Configure screen to configure unit settings.
Configuring System Settings
To change general system settings, from the Home
screen, select
Configure
>
system
.
simulator—turn Simulator Mode on or off and set
Simulator Mode options. (If you set the unit into a
Store Demonstration mode during the initial unit
setup, this setting will be named Demo.)
language—select the on-screen language.
beeper/Display—select
beeper
to set when the unit
makes audible sounds. The three settings are
Off
,
Alarms Only
(default), and
On
(keys and alarms).
Select
Display
to switch between Day or Night modes
and brighten or darken the backlight.
GPs—view GPS satellites, turn WAAS/EGNOS on
or off, and initialize the GPS receiver.
system Information—view system information and
restore factory settings.
Event log—shows a list of system events.
Overlay Numbers—set the styles for Wind and Next
Turn numbers.
Changing Units of Measure
To change units of measure, from the Home screen,
select
Configure
>
units
.
system units—this is a quick global setting that
defines most of the individual units of measure listed
below at once.
statute
(mh, ft, ºF)
,
Metric
(kh, m,
ºC)
, or
Nautical (kt, ft, ºF)
.
Depth—individually set the units of measure for depth
to
Feet (ft)
,
Fathoms (fa)
, or
Meters (m)
.
Temperature—individually set units of measure for
temperature to
Fahrenheit (ºF)
or
Celsius (ºC)
.
NOTE: You must be receiving NMEA Sonar depth
data or using a Garmin sounder module to view
depth and temperature information.
Dist, spd, Elev—individually set the units of measure
for distance, speed, and elevation readings.
heading—set the reference used in calculating
heading information.
Position—change the coordinate system in which a