About the water softening system – GE PNSF31Z01 User Manual

Page 10

Safety Infor

mation

Operating Instr

uctions

oubleshooting T

ips

Customer Ser

vice

About the water softening system.

NOTE:

and

HARDNESS

(factory default) do not show in the

display, press

SELECT

until they do.

Press the UP or DOWN button to set your water hardness
number in the display. DOWN moves the display down to 1.
UP moves the display up to the maximum setting of 90.

NOTE:

Each press of a button changes the display by 1 between

1 and 25. Above 25, the display changes 5 at a time…25, 30, 35, etc.
Holding a button in changes the numbers twice each second.

When the water hardness number shows, press

SELECT

to set.

You can get the grains per gallon (gpg) hardness of your water
supply from a water analysis laboratory, or call and ask your
local water department, if you are on a municipal supply.

Set Water Hardness Number

NOTE: RECHARGE TIME

and a flashing

2:00 AM

(factory default)

should show in the display. This is a good time for regeneration to
start (over in about 2 hours) in most households because water is
not in use. HARD WATER is bypassed to house faucets during
regeneration. See the

Automatic Hard Water Bypass During

Regeneration

section.

Press the UP or DOWN button to set the desired regeneration
start time.

NOTE:

Each press of the buttons changes the time by one hour.

Holding the buttons in changes the time twice each second.
Be sure to observe the AM or PM

as you did when setting

the time of day.

Press the

SELECT

button once more.

The display shows the present time of day and

RECHARGE

TONIGHT

Set Regeneration (Starting) Time